Wildland Normandy Auto 120 Soft Shell Roof Tent

The Wildland Normandy Manual roof top tent is a manual version soft top roof tent.

By fixing the three supporting rods manually can easily set up the roof tent in seconds.

It is the lightest and most economical type of Wild Land roof tent. The net weight is 40kg only and can bear a weight of 300kgs

With a Wild Land patented Hydraulic cylinder mechanism set up and fold down is incredibly fast and easy. The patented design has gone through tested iterations to make it as fast and unassisted as possible.

Suitable for most vehicles

Roomy space for two or three persons

5cm mattress provides comfortable sleeping experience

Two big shoe pockets on both sides of front door

Telescopic aluminum alloy ladder is removable and bears up to150kg

 Structure: Normandy Auto 120

Inner tent size: 200x120x70/110cm

Outer: 217x134x95/134cm

Closed tent size: 226x133x18cm

Packed size: 229x137x22cm

Net. Weight: 46.5kg (including ladder)

Gross Weight: 60.3kg

Material Fly: 210D rip-stop polyoxford PU3000mm with sliver coating, UPF50+ Inner: 190G rip-stop polycotton PU2000mm Floor: 210D polyoxford Pu2000mm

Cover: 600g/1000D high density PVC Frame: Aluminum pole, telescopic Alu. Ladder

Roof Tent Safety Advice

WARNING: Improper installation or use of your roof tent could lead to serious injury or death. Always follow installation instructions carefully to ensure proper fitting onto your vehicle and safe use of your roof tent. Check with your vehicle manufacturer for specific roof rack loading capacity.  Not all factory roof racks, or aftermarket roof bars can safely accommodate tent models. Always use a good quality product. Improper use of equipment can lead to personal injury, damage to your vehicle, roof tent or other road users.

VEHICLE WEIGHT LOADINGS

Consult vehicle manufacturer for information on your vehicles ‘maximum load’ for any roof bar installation.  Obtain this to ensure the relevant product kg is below the manufacturer recommendation. Also see further notes on Static and Dynamic loadings.

ROOF BAR LOADINGS

These may be different to your vehicle must also accommodate the product weight recommendations.

Important Advice

• The weight loadings on your vehicle / roof bars MUST NOT be exceeded, this could lead to serious consequences. A vehicle and heavy weight is involved so extra care must be taken.
• Periodic Journey Checks – Once you fit the Roof Tent take a short test drive to check safety.  Do not embark on a long journey before this check. Once starting a journey check all bolts / fixings connecting the roof bars and the roof tent after approx. 10 miles, then another check after 50 miles. You can if you wish use additional nuts, or wing nuts for added security.
• Do not drive with the tent open.
• Do not cook or bring cooking, BBQ or fossil fuel heating devices inside or below the roof tent.
• Always ensure the ladder is secure and on a level surface.

Static & Dynamic Loads

• Take corners slower.
• Brake in advance and smoothly.
• On rough or uneven ground, the Dynamic load can increase significantly, and extreme care needs to be taken. The ‘jolt’ effect of uneven ground cannot be quantified so the driver needs to take extra precautions on these surfaces.

Product Care

1. Clean and dry your tent after each camping trip:
2. Open the tent fully and brush / vacuum inside
3. Clean the fabric as needed using a mild detergent, warm water, and a soft to medium brush. Rinse fabric of all detergent prior to drying.
4. Dry tent in the sun with all windows open. The tent must be completely dry before storage, or mildew and mould may occur. This is especially necessary after camping in rain or wet conditions.
5. Using a small brush, remove dirt from zippers. Use a silicon spray to keep zippers lubricated.
6. Wash mattress pad and hang to dry.
7. Store your roof tent in a dry location, ideally wrapped in polythene or other suitable cover if storing for long periods of time.